Using a serial link on a xen dom0
By default xen will bind it’s console on ttyS0 and following message is visible in /var/log/message
kernel: Xen virtual console successfully installed as ttyS0
At this moment you can’t send messages over a serial cable connected to your system because the device is already in use by xen.
Adding following parameter in the grub config file, the default ttyS0 will be changed to whatever you provide or removed if you enter xencons=off.
module /boot/vmlinuz-2.6-xen ro root=/dev/sda1 xencons=ttyS9
ttyS0 will be unused after a reboot and the module providing the serial devices can be loaded, the module is called 8250.
Normally the serial modules are compiled in the kernel and nothing is implemented to load them during boot. But we want to load when the system is booted. Therefore I added that module in /etc/modprobe.conf:
# loading the module for serial devices. We want this at boot time therefore it is aliased to snd-card.
alias snd-card-0 8250
alias snd-card-0 8250_pci
alias snd-card-0 8250_pnp
This is how you can test the serial connection between 2 machine:
* On machine 1 open the serial device: cat /dev/ttyS0
* On machine 2 send a message over the link: echo “Hello World” > /dev/ttyS0
The message should appear on machine 1.